Maxx Air Vent Corp 00-06401K Maxxfan Dlx Vent 12V Smoke

One of the most beautiful fans I have used for my caravan. Thank you

I had a different brand, without a remote before. Hardly used it. The fact that I can turn fan on/off without getting in the back & having to wind it up & doing the same to turn it off. Its quieter, looks better & works great. The remote has a couple of times not wanted to work, like signals on, but no action. Turn remote on & off a couple times & it worked. But its great & thats better than the odd hiccup

届くの遅くて予定がずれてまだ取り付けしてませんし開けても無いがMAXファンだから物は間違い無いと思いたい。

Fácil de instalar O controle remoto da imenso jeito Poder usar em andamento e mesmo com chuva é excelente Ajuda bastante a controlar a temperatura O sistema automático é óptimo Fácil de limpar as pás e a rede mosquiteira Bom preço!

We purchased the 06401K Maxxair DLX Vent to replace the rooftop RV Air Conditioner in our Lance Squire Lite truck camper, because we almost always boondock camp (no generator). This unit has no remote, is manual opening, and only exhausts air at 4 speeds....we went with the simple one. At the lowest speed, the fan noise was unnoticeable. At high speed, it was tolerably quiet. Installation is definitely a DIY project, as long as you're comfortable safely accessing the roof of your RV, and working with power tools and wiring. If you're removing a 115v AC unit as we did, be sure you're disconnected from all power sources before starting, and those units are heavy and awkward up on the roof....be safe. The entire fan assembly fit perfectly in the 14"x14" opening, which, from what I understand, is pretty much the standard size opening for RV roof vents and AC units. I cleaned up the old opening of all old sealant and dirt with rags and acetone (our roof is stainless steel sheet...other materials may not be compatible with strong solvent cleaners). We located12v power just a few inches away at a light fixture. The wiring to the fan motor is about 16ga, and about 18" long, so it was plenty sufficient to reach. I had to drill a small hole in the wood that framed the opening to fish the wires through, and easily retrieved them through the hole for the light fixture wires. The inner cosmetic trim ring will need to be cut down to adapt to the thickness of your roof. I just used a utility knife backed with a piece of wood and guided with a straight edge. The material was thin and soft to get through with a couple of passes. Other stuff you'll need to complete the project: Rags and cleaner/solvent to clean and prep the roof Butyl seal tape to place between the roof and the exterior flange Lap Sealant (one tube is plenty used generously) to seal the screws and exterior edge Some wire butt splices to crimp wire leads to the power source. Maybe some electrical tape to make things neat. Tools: A pry bar to gently release the old fixture from the roof, after removing fasteners. Scrapers for roof prep #2 Screwdriver (a drill/driver makes fastening into the roof much easier). Length of stiff wire or wire fishing tool, to pull fan wires to your power source Wire strippers/cutters/crimper I expect this to be the most useful upgrade we've done yet to the camper....it will allow some diffused light and ventilation where the unused AC unit did not. Doug & Heather ....on a beach somewhere!

Beautiful fan with remote!!! Great quality and easy to install, perfect fit! In the kitchen and draws heat out will cooking and provides afternoon cooling! It has rain censor as well. Thank you!