4 Channel 3 Pin Multi Network XLR Cable Breakout for Stage Sound Lighting and Recording Studio Male and Female to RJ45 Ethercon

These use 2 cores for each XLR so obviously your audio signal becomes unbalanced and you will hear unwanted noise

Exelente producto solo recuerda que solo funciona con cable ftp con malla y conector blindado ya que por la malla se trasmite el pin 1

Recently moved audio equipment to a loft/balcony at the church and DID NOT want to run snake cables along walls and floors - Cat5 happened to be already in the walls, so this seemed the perfect solution. Instructions say to use Cat6, but since it was only a 75 foot run, we thought we'd see how it works - NO NOISE, NO CROSS TALK, WORKED PERFECTLY! You literally just plug a Cat5 into each box and you're done. We fed three instruments UP to the mixer and the monitor output back DOWN on the 4th channel.

Not good

This is a fantastic piece of gear. Rock-solid build, clean signal, and zero noise even on long cable runs. The connectors lock in perfectly and feel like pro studio quality, reliable, sturdy, and worth every dollar.

I've purchased six of these over the last couple of months. I've used all six of the female XLR ends, and I've used only two of the male ends. In all cases I've used the version with 4 wires (fan out) instead of these stage boxes on the other end. So even though I've stockpiled 4 unused male ends, I still find these to be cost effective. I've run 150' CAT6 Shielded Twisted Pair (STP) with these with no noticeable noise or cross-talk, even when I turn up the gain on an unused channel and boost the headphone volume on my mixer. I would guess the cross-talk is at least 80dB down, and that is perfectly appropriate for all of my sound system needs. I've taken most of these apart to drill holes in the back and permanently mount them around the chancels of churches. They are well constructed inside with a good quality circuit board that connects all five connectors. To take one apart, undo the four screws on the end with the Cat6 connector and pull that end straight out so that the front panel with the 4XLRs slides out with it. Then mount the empty box and slide the connectors back in to close it up. I'm also carrying a female box end and a male fan-out end in my mobile sound system. I find it faster and much easier to run a single Cat6 cable compared to running a multi-core snake or 4 mic lines. It is very easy to carry 4 Cat6 cables of various lengths, and use the smallest one that reaches. These make my whole stage look neater.