Ubiquiti Universal Antenna Mount UB-AM (Original Version)

I bought one of these to install a Nanostation M5 and Unifi Mesh on the outside of a cabin. This product is very well made out of rigid metal. The pole itself can be mounted either way (either with short or long end in bracket). This permits antennas to be mounted in a variety of different angles and distances from a building. Although the mount is not particularly large, the bracket is very large. Although I do not have the specific measurements, it is taller than a 2x6 board. This is important to note if not mounting on a wall/flat surface. In my application, I cut a board to mount at the peak of the building. Overall, this antenna mount seems very solid and is long enough to securely mount both my access points. I would recommend this product.

Item arrived on time and met my expectations. As mentioned in other post, hardware not included. My antenna fit perfectly on it and it is working as intended.

It was perfect for the 60ghz wave nanos and wave micro that I needed to mount the equipment across 8 different buildings.

Fairly straightforward product. Installation was simple. One star removed because when I installed my antenna, the tube completely collapsed. See picture attached for details. I was using a simple wrench and didn’t really forced. The tube just collapsed as if it was made of paper... I only stopped because I wanted to check the alignment and realized that I was already way over the tightening required.

For those of you seeking a mount that is white in color, this is more industrial gray (NOT WHITE). I assumed that this would be white in color because of the picture and I wanted it to match the appliance that I plan to mount on it. Not too big of a deal, I just spray painted it with a can I had in the garage and all is good. Otherwise, I'm very pleased and expect it will work perfectly for intended purpose.

Great product to support your WiFi transmitter. I have mounted to wood, metal and brick with ease.

It was used to mount a Starlink antenna on a fence post. It is exactly what I needed to finish my Starlink project.

I read alot of articles on the interweb about wireless bridges and was still unsure. I ordered these units after watching a dozen or so YouTube videos on installation. I first set them up across the room from one another as a test and they linked right up... Ran the Cat6 cable to the side of the house and set up the first unit. They come labeled Access Point and Station. (Access Point is the unit that hooks to your internet modem in you house) I then set up the second unit (Station) at my pole barn about 800 feet away. I had to wait till dark to align them because the LED signal bar lights were hard to see in the daylight. After aligning them I set up the Router in the pole barn. Wow !!!! it works. WiFi, Internet good to go. Instructions were a little vague and hard to follow, but if you watch a few videos online you'll get the idea. Remember....(Access Point is your house) and (Station is your Remote setup....barn, second house, tree fort ETC...) I hope this helps !

Basically the old bell roof mount for their satellite receivers .. good solid and last a long time .

This mount fits perfectly to Starlink Gen 2 dish. No need for other converters and add ons.

Achetée pour monter un point d'accès Wi-fi en façade de la maison, ça fait le job. Mais attention: prévoir des rondelles en caoutchouc à placer entre vos tirefonds/vis et la platine d'accroche car la peinture est très fragile. Le pourtour des 4 trous d'accroches sont maintenant écaillés....

Gran calidad de materiales, acabado, funcionalidad, mejor que otros que he comprado, trae su tornillería completa, el diámetro del tubo es un poco ancho, pero nada que la fijación con abrazaderas o cinturones no solucione, recomendable al 100

Support ppur antenne Ubiquiti, bien mais les trou de fixations pourrais être mieux étudié.