2 Pcs Rifle Scope 30mm 25.4mm 1 inch Tactical Light Flashlight Mounts Scope Ring Adaptor with Picatinny Weaver Universal Rail

This Picatinny rail adapter is 30mm with a 25.4mm plastic insert filler to fit most standard 1 inch or 30mm rifle scopes. I used one on a scope to allow me to mount a reflex sight above or sideways on the left side of the scope. I installed one on the front end of my 12-gauge pump shotgun tube magazine for mounting a green laser. My pump grip stops about 3 inches short of the barrel clamp so on my shotgun there was plenty of room though it would not easily provide mounting for a reflex sight as the configuration is not reasonable for that. I did need to remove and reinstall the barrel to get the strap between the barrel and the magazine tube. I just removed the threaded cap at the end of the magazine tube, slid the barrel off, attached the picatinny rail adaptor, and reinstalled the barrel. Took about 5 minutes with the only tool required being the hex wrench that came with the Picatinny rail adapter. Your magazine tube may be a different size. Mine is about 25.6mm and fit without modification of the plastic spacer. I will probably buy again.

Product is of good quality, fits well and I am satisfied with my purchase.

Good product

I ordered these for my pellet gun for a bid pod or I can put my tactical flashlight on it I have it also on my 12 guge as well thanks

I needed a mount for my scope camera and was worried that I would have to mount it to the barrel. However, this mount fits both of my scopes without having to adjust their mounts. The camera fits perfectly on top.

They are a must for mounting hunting lights on your rifles for night hunting.

Purchased it for one of my relatives. According to them great value for money

I purchased this for so I could mount a light on my BIKE and the diameter was a tiny bit big. But 2 small strips of mounting tape on the inside diameter and it fit like a glove and NO SCRATCHS. AND I have an extra , just in case I get another ... bike