Universal Garage Door Remote Compatible for LiftMaster,Chamberlain,Linear,Stanley,Wayne Dalton,Craftsman and More Garage/Gate Door Opener has Learn Button or DIP Switch on Opener

I have two separate garage doors. One with dip switches and one is rolling code. This can handle one of each or two rolling codes. Seems to be able to be programmed to just about every type of opener. The instructions are a little quirky. After pressing the program button inside the battery compartment, you need to press either number one or button number two (which ever you are trying to program) the same number of times as listed next to your garage door opener in the instructions. Then press the program button and you are done. For rolling code openers, you will also need to press the learn button on the opener itself to learn the signal from the remote control. The instructions imply that you need to press either button number one or button number two once and then press it again for the number of times listed in the instructions. You only press number one or number two buttons for the total number of listed in the instructions. I had a hard time with this, maybe I just didn’t read it clearly. All in all works very well. I have three!

This universal remote works perfect for the Linear opener LCD 850. Just follow the instruction on the chart, very simple, keep the garage door close, press the learn program button on the remote till blue light comes on, the Linear opener is press “1” time on the remote control button. Then press the remote control learn program button again. Next press the learn button on the linear garage opener then press the selected remote control button and the garage door will open.

Bought three. Started acting weird when it got cold. Figured out they dont work when cold. Not sure what the cutoff is but I think its at least 60 degrees which is obviously ridiculous. It was around 50 tonight and they didnt work. Have to leave in the house overnight to work in the morning and have a long drive with the heat on to work when coming home.

The remote works fine, and it was easy to set up. Unfortunately, I purchased three of these and the biggest problem is that because there is no protection around the buttons, they are very sensitive because they are very easy to hit if they’re in a purse or backpack. The remote does what it’s asked to do, but a lot of the other remote controls, have like a small lip around the buttons to protect from such mishaps. If you just clip it on your car visor, then this remote is perfect.

This is easy to program and works great. I have 2 garage door opener at my house. One is brand new and the other is from 1991. This remote was able to be programmed to both. I was able to select which button was for dip switches and which one was for the new opener. Very satisfied.

Amazing, programmed my Chamberlain Garage Door with rolling codes to one button and my older door opener with micro switches to the other button. Easy to do. I am over 70 and not a techy, but was done in less than 10 minutes for each door. I don't have to carry two remotes any more. This is the only remote I could find that could do both, and by the way, considerably lower cost than just replacing my Chamberlain remote.

Works ok. Dosnt work from more than 10 mims

Nicely registered my rolling garage door remote but unable to register my gate remote. Attractive with great potential.

As per caption. Followed instructions, several times, then resorted to YouTube videos. Clearly not compatible. Return process a real pain too. These have to be mailed back to US.

No funciono en mi motor. mejor cambie el sensor directamente en el motor y ya venia con un remoto.