Century Drill & Tool 95305 8-32 NC Tap and #29 Drill Combo Pack, Steel

They both worked well for my use in aluminum.

WORKED WELL

Used it for creating new holes on a air compressor manifold.

Good quality and value. Worked for me.

Got a little trigger happy zipping bolts in on the kids go cart I rebuilt with my new impact.....one to many ugga duggas not thinking and rolled the threads on the new predator 212's shaft. Tap cut like a knife through butter. I was able to chase the threads and get the CVT back together. Bailed me out of a pickle for sure. Thanks

nice sharp drill and sharp tap. ran this drill around 300rpm drilled and tapped 4 stainless rods for heim joints. Cutting just fine.

I bought this to drill a hole in a aluminum gas tank so I could install a petcock. This did the job perfectly without any issues.

The media could not be loaded.  This review is for the NPT 1/4-18 drill/tap set. The drill does not bore a nice hole at all, even though the metal the bit is made out of seems to be of good quality and it came quite sharp. The tap is of good quality. Overall decent value set, although I'm really not sure what's up with the drill bit. Even though the whole that was drilled wanders a lot, the tap did end up removing enough material so that it was not an issue, other than affecting the tap's square alignment to the hole. I made a video, attached.

Quality precision tools +

Tap is high quality made in Japan, the bit is cheap Made in China junk.

It arrived quickly. I haven’t taken it out of the package yet but both bit and tap appear to be very straight and good quality

Worked great for what I needed it for. I installed an egt sensor in my exhaust manifold on a Cummins 5.9

Nice to get the tap and drill as a combo so they work great together, worked for drilling and threading a hole for my EGT and boost pressure gauge.