Rack-A-Tiers Nut Blaster (XL 5/8" Opening) - Universal Wire Nut Twister, Wire Twisting Tool, Wire Nut Driver, Wire Connector Drill Attachment, Wire Twister, with 1/4″ Hex Shank (72101)

Use it all the time at work, easy to pre load a wire nut and have it ready to go. Fits my pouch perfectly, i don’t keep bits in my impact in case it drops so this functions well in a quick change application for me

One of the better quality nut twisters I’ve owned.

Works great for larger wire nut and wing nut. Unfortunately the one with out wing it’s tighten it up but skips, still need to be tighten by hand.

This thing is fantastic!!! No more sore fingers from twisting wire nuts all day long with my fingers. I don't know what people are doing to break these, because if you use them correctly this should last a life time. I worry more about losing it rather than breaking it. For proper usage, twist the wires together with good pair of lineman pliers. Snip the tips on both wires so they are the exact same length and that one wire is not pointing out at the end, otherwise it could pop out the end of the wire nut. Then hand twist the nut on about two turns just to hold it on the wires. Use this twister for about two or three turns and its set good and tight. Awesome tool!!!

This tool works great. It is saving a lot of wear and tear on my hands. Be sure you have the ends of all the wires flush because if one is longer than the others it is easy to overdrive the wire nut and send the long wire poking out the end of the nut. I am using it in a small 4.5 volt drill which turns fairly slowly which allows me to control the tool well and between the low speed of the tool and making sure all the wires are the same length I have stopped the issue of the wires poking out the end of the nut. I recommend this tool for anyone who uses wire nuts. It is a hand saver.

What a wrist and finger saver! If you've ever wired a house, you know how hard it is on your fingers and wrists twisting those wire nuts all day long. Even with gloves on and wrappings of duct tape to get more finger grip, my fingers would be raw by the end of the day when I was remodeling my home. This tool literally takes the pain out of twisting wire nuts! I use mine on a ratcheting driver and it works perfect with winged wire nuts. No pre-twising of the copper with lineman's pliers is needed; just insert the wires, turn on the drill, and stop once it's twisted the wires a few turns. The product is not meant for non-winged wire nuts so be sure to buy the right wire nuts.

Does exactly what it is supposed to do.

This thing works excellent the only thing you have to watch out is when using nuts that do not have the wings on them if it's not fully pushed in and you go a little trigger-happy it will spin the inside of this out. But I have successfully used it on everything from an orange all the way up to a blue with and without the little wings on them. the electrician's that I work with have never even seen one of these and every last one of them has bought one after using mine. I do recommend for the cost buy 2 because one of them will eventually get worn out when you're in the middle of a job.

Tired wrist, or doing alot of splicing? This is a great tool to have. Is best if you have a seperate impact to put it in so you don't have to swap bits, but still good none the less.

I've always been very skeptical of electricians who don't pretwist their, but after I got Carpol Tunnel someone at work recommended these. The first dozen or so connections I neurotically checked every connection that they were tight and was pleasantly surprised. I recommend using with the dewalt gryo driver, but apparently they are being discontinued so something lightweight and low powered would be best. Do not use on an impact driver!!!

Parfait

Does well what it supposed to do!

Wrist saver!