150 mm (6”) Inline Bathroom Extractor Fan with Run-On Timer – Quiet Loft-Mounted Ventilation for Shower, Toilet & Damp Control

Brilliant, easy to install following instructions and works well, the mirrors used to be fully forged up with my old one and now don't show any fogging

Great item, simple to fit. I noted other comments about water ingress in to the motor and/or the connection box where the PCB is so added a little silicon sealant at the wire exit and entry points as simple to do and costs nothing. I have the unit hung and not screwed to a floor or truss so it doesn't create a potential vibration/noise, fan is quiet because it is outside of the room in the roof space unlike a ceiling fan. Time will tell on the ability to remove the shower room steam but so far it seems better than the previous ceiling fan, the vent I bought with it just replaced the original ceiling fan but I removed the plastic gauze from it so it doesn't get blocked with dust/fluff over time.

Easy to install. Seems to work fine. Warranty registration a bit bothersome - it's on the Blauberg site (so this is a Blauberg fan, which I'd guessed) and requires the serial number which I can't find on the box or paperwork, so will have to climb into the attic again for it. Note that the noise level per the fan rating isn't what is shown on the Amazon listing (others have commented on this), but it seems quiet enough.

Easy to install ,runs very quite . Will buy again

Installed to remove steam from a shower. Best features are: Removable leaving all ducting in place, so great for future servicing/replacement. Quiet running. Integrated overrun timer. Dual speed. My experience: Works well and is fairly quiet though I mounted it onto a beam and sound is conducted to the house so I will remount onto a foam pad to silence it completely sometime. Sound is not intrusive though. There are some reviews mentioning water getting in to the electronics but it is down to how you mount the unit and the ducting you use. This time I mounted it vertically with minimum amount of ducting, venting to a vent tile in the roof. I would say avoid uninsulated ducting as you will get condensation inside which will lead to water ingress, especially in winter months. Keep the runs short as possible and with a slope so condensation cannot pool in the pipe. Better for any condensation to run back into the shower where it is already wet rather than anywhere else, though I see no water as the 30 minute overrun probably dries it all out. The low speed doesn't seem to be much slower but is a little quieter than full speed. To reduce noise especially for night time, I wired a relay into the unit so it runs full speed when the bathroom light is on then low speed for 30 mins when the light is turned off. Seems a good solution. You should definitely incorporate an isolation switch so all lines can be disconnected for servicing/replacement etc. Good product - would buy again.

Great fan unit. This is my second one of these and I've replaced all Expelair noisy contraptions with these quiet and well behaved in-line units. They're more powerful - you can feel the draft under the bathroom door - and have operated for years without showing overheating or sounding like having a Cessena stuck in your bathroom wall. Check out the fps ratings (cu ft per sec or farts per sec?) I think they're safer. Some of the cheaper wall units just use a large resistor in their circuits that can get hot and age - not good. These units don't have that issue. Don't forget to buy a multi-pole fan isolation switch, 3+1 mains cable , lots of pipe and fittings and make sure that its all fitted correctly - use a professional (electrician) if uncertain or illegal to DIY.

Very good value. Replacement to a very old fan & very impressed with the quality & function.

Immediate improvement to extraction capabilities in the bathroom. Passed the tissue test whereas my previous fan couldn't cut the mustard. Easy to install, and clever system to easily detach the middle element of the fan for maintenance. Only improvement for me would be to have the timer adjustment more easily accessible, like on an external potentiometer or an access hole with a bung insert to prevent dust access. As it stands it's behind the cover for electrical connections, which just means you need another tool to remove the cover, and then adjust. Could've just been that bit easier.

لا يعمل

Gran flujo de extracción de aire pero en mi caso, nose si por defecto de fábrica o es que esta diseñado así pero por las uniones centrales se escapa gran cantidad de gases, humos o lo que estés tratando de extraer, con la consecuencia de que se te llena la habitación de lo mismo que tratas de extraer. He pedido otro nuevo por si acaso es algún defecto (aunque no lo parece y tiene toda la pinta de que está mal diseñado) y si vuelve a pasar, lo cancelo de nuevo.

Cumple con lo mencionado y muy silencioso

تسحب الهواء بشكل جيد ولكن صغيره الحجم وبلاستيك خفيف

De momento funciona bien y me parece suficientemente silencioso