DAOKI 100Pcs Tact Button Switch 2 Pin DIP 6x6x5mm PCB Momentary Tactile Tact Push Button Switch

Works well! Very worth the price as it comes with a lot and are super simple to use since it only has 2 pins. They're smaller than I expected which is not the manufacturer's problem. They worked well for my project with a breadboard and arduino nano! I connected 1 pin to the (+) rail (that was already connected to 5V from the arduino), then the other pin was connected to both an arduino digital pin as well as to a resistor that went into the (-) rail (already connected to arduino GND). I used a test code, checked the serial monitor, and it worked! // **** BUTTON TEST **** // const int buttonPins[] = {5, 6, 7, 8, 9}; // Your 5 buttons // const int numButtons = 5; // void setup() { // Serial.begin(9600); // Start Serial Monitor // // Set all buttons as inputs // for (int i = 0; i < numButtons; i++) { // pinMode(buttonPins[i], INPUT); // assumes you’re using external pull-down resistors // } // } // void loop() { // for (int i = 0; i < numButtons; i++) { // int state = digitalRead(buttonPins[i]); // if (state == HIGH) { // Serial.print("Button on pin D"); // Serial.print(buttonPins[i]); // Serial.println(" is PRESSED"); // } // } // delay(200); // So it doesn't spam the monitor // }

These are nice pushbuttons, useful when you only need to control a single circuit. Easy to handle, fit well in a breadboard and are easy to solder.

Used these to replace some rubber dome switches in my 1999 Land Cruiser. They are excellent, no problems yet. I like the mechanical click so much more, I replaced even the ones that were still functioning with these.

Bueno

Washing machine power and start buttons were intermittent. These switches were incredibly cheap and the perfect size. Only done a couple of laundry loads but these are working as new. If they fail I have 98 more to replace them with as spares.

I needed these switches to repair a keypad that wasn't responding. I found the right switches and ordered them. They arrived quickly and were easy to install. They worked perfectly and saved me hundreds of dollars. If you need replacement switches, I recommend these.

Tiny they are, but perfect for those tiny jobs!

Saved my 16 year old Whirlpool Duet by replacing the hold to start switch on the control panel circuit board.