SB components Case for Raspberry Pi 4 b / 4 Model B /4b (Pi 4 Board Not Included) RoHS Compliant

Great for the price. Obviously not completely sealed as give access to gpio headers but it's great. Easy to install. Plastic quality is good. Not being used for any heavy lifting, so temperature should be fine.

I needed a nice, cheap case for my new Raspberry Pi 4. This was very cheap and is perfect for those who just need a simple case.This case comes in two pieces and snaps together perfectly. The case feels strong, the clear plastic looks great and I can see this lasting me until the death of the Pi itself.I haven't attached any fans but the fixtures present for them look like they will do just fine if I do decide to add one at a later date.

I've been using my Pi 4 without a case since I bought it when it was released, though admittedly it's seen little use. Decided I wanted to try out some software on the Pi and bought the cheapest prime eligible case on amazon, not expecting much but thinking that the Pi would at least be protected. I'm pleasantly surprised. The case is a simple two-part plastic construction with internal clips to hold the Pi board in place. The top then clips on, leaving access to all external and internal ports through perfectly positioned cutouts. There are vents on the underside and even wall mounts. Rubber feet would have made it truly perfect and perhaps an optimal cover over the GPIO pins if you're not using them. But overall it's a cracking case for a bargain price and does exactly what it says on the tin.

great little case, gives me peace of mind when i accidentally hit or knock my Rpi4, probably not the sturdiest of cases but for the ridiculously low price what else could you expect.

Fits Pi well but the memory card slot is tight and can use loss of data on the card. well it did for me.

In general, all fits fine. No problems with closing, or anything. Sockets fit great in adequate holes. Only problem is - when installing active cooling, after closing it - top lid is blocking the fan from spinning. It simply pushes the fan down, so it cannot spin - it should be about 1mm higher and it would make it a perfect tiny case. I'm cutting only 1 star down, as they doesn't say anything about being OK for heatsinks with fans in the description.

Its quite easy to install on the pi, does what it needs to do perfectly

I'm no expert. I needed this for Flightradar24 to get a Business subscription so watched the YouTube videos and followed the guidance and hey presto, works as expected with no issues. If that's what you need it for then it works :-)