MEASUREMAN 2" Dial Size, Glycerin Filled Pool Filter Pressure Gauge, 304 Stainless Steel Case, 0-35psi/250kpa, 1/4" NPT Lower Mount

Great price and quality sturdy construction I bought other brands and they did not last. This looks like a good quality item. It actually works the othes just leaked water and didn’t even register. Will recommend to others.

Great Gauge for the price.

This is a really nice gage. I always buy liquid filled gages now, they are more reliable and less prone to damage if there are pulsations in the pressure. This one has a more suitable range for my cartridge filter which never gets above 15 PSI. I should have replaced my old gage long ago, this one is much easier to read and has more resolution. When clean my system (in ground with a 1 HP pump and cartridge filter) only runs 2 - 3 PSI. The old gage didn't move off the peg at those pressures. I like to track the pressure when I've just cleaned because its the best way to track how clean the cartridges are.

Have had this gauge on my pool filter for quite sometime now. Has been working great. Has not lost any fluid, accurate, and the sun has not affected it. If I ever have to, I'll buy again.

This isn't the first time we've had to replace the pressure gauge for our pool...but I have a feeling this gauge will last longer than the previous ones. It seems well made, and the innards are bathed in glycerine, which should help prevent deterioration. It screwed right in where the old gauge had been and seems accurate.

Just installed on my Pentair CCRP200, it was super easy install and this gauge is 99 times better than the cheap plastic gauge I had before. Funny story, I knew my filter needed to be cleaned, and I knew my gauge was a little hanky HOWEVER I usually would get a decent reading when I tapped on the gauge. After installing this gauge my pressure was 29psi at high speed, where as the old gauge was showing 19psi!! So I immediately cleaned the filter and am now cruising around 18psi. Still a little high, but I'm due for an acid bath anyway. The build on the gauge seems super nice and is pleasant to look at. Made my equipment look a little less "janky".

Great

Works well. I did have to put a few extra rounds of teflon tape to seal where it mounts to pool filter head as it seemed a little looser than the oem, but i like the bright Blue and Red marking on the gauge. Seems to be high quality. I only wished the lense was glass instead of polycarbonate as the OEM got so dingy and yellow, it was hard to read after only 10 years. I am happy with this overall. It does seem to read a little bit different from my OEM by about 3 PSI. I plan on testing it over the winter to compare to a standard calibrated gauge at work to see how close it really is. I will update if it is off by too much.

I've had a new PSI gauge for my sand filter every year because the one before would always appear to look dirty and condensate inside the housing. Now I just purchased this one but already I can see it's not a flimsy made gauge. It has weight and good workmanship went into making it. I always store the gauge inside during the months my pool is closed so I have a feeling this one will be just fine and not look shabby next year

Yes fit well and working well so far

De bonne qualité et l’écran est claire

Quality item, liquid filled.

Works great I have a Hayward filter to a 40x20 Inground