IronWolf Pro ST6000NE000 6 TB Hard Drive - 3.5" Internal - SATA (SATA/600)

I have 6 of these running in my Synology NAS and have had them running for 24/7 for several years. I finally received a predictive failure alert from my NAS and had zero issues ordering another one to take its place. Zero data loss, and no downtime! I’ve used these drives on dozens of NASs for clients and myself and will continue to do so!

Purchased two Seagate Ironwolf Pro 6TB drives to complete my Synology 8-bay NAS. Have been running with 6 drives with the intention of getting the last two as hot swap drives when the price was right. Popped these two in and they immediately spun up and added the extra safety I was looking for. They also arrived much quicker than expected since I was not in a rush.

Used in a Synology Diskstation, Synology lists it as an “approved” drive. While in the NAS I would get error messages about power disconnects from the drive. Replaced it with a WD red, issues gone. Drive works fine and passes all diagnostics in a desktop machine. Can’t really fault the drive, more likely a NAS issue. My Diskstation is about 10 years old but still works fine.

I think it was like 5.5 TB instead of six but it's fast and good so I'm fine with that

Bought a Seagate IronWolf Pro ST6000NE000 6 TB Hard Drive from this seller. The HD failed after 2 days in operation in my Synology NAS. It was operating in a RAID 5 setup, but after 2 days the drive failed not even able to enter S.M.A.R.T diagnostics to understand failure of drive.

Arrived with 3 bad sectors and the NAS would not use the Drive in a RAID 5 configuration with this many bad sectors.

I purchased 7 ST6000NE000 for my Synology NAS. 4 of them are defective after installing them inside the NAS. Seagate didn't provide any support to test the drives besides the usual response "Return the product to your vendor". NEVER TRUST SEAGATE ANYMORE.

Prodotto di ottima qualità, esattamente come da descrizione. Molto soddisfatto dell'acquisto.

Primero: Una buena unidad. Adquirí esta unidad para agregar tolerancia fallas a una NAS. El disco previamente instalado es idéntico, por lo que puedo decir que funciona muy bien, es silencioso, cumple su función sin dar problemas. Así que del producto en si mismo no tengo queja. Lo malo es que llegó sin protección alguna, en un sobre de papel. Sin caja, ni hoja de garantía, ni nada. Asi, en la bolsa antiestática dentro de un sobre. Normalmente lo regresaría, pero amazon ya no tiene este modelo disponible. Así que lo instalé en la NAS. Aún está en el proceso de inicialización. Ya veremos que tal funciona... ACTUALIZACIÓN: Confirmado. Unidad dañada. Devolución procedió sin problemas.

Bu üründen farklı zamanlarda toplam 3 tane aldım, 2’si bozuk çıktı. Harddisk’i mektup zarfına koyup göndermişler ne bir koruyucu ile sarmışlar, ne de taşımada dikkat kırılır gibi uyarı koymuşlar. Amazon’dan alıyoruz içimiz rahat olsun diyoruz, 1 haftadır yaşadığımız şeye bak. Tam bir haftadır bir Raid kuramadım hatalı gelen ürünlerden. Üstelik 1 haftadır kuramadığım Raid’de bir de mevcut hdd’lerden birinde bir sorun çıksa veri kaybı da yaşayacağım. Özet tanım: amazon bu taşıma mantığı ile kendisinden asla hdd alınmaması gerektiğini göstermiştir. Kesinlikle tavsiye etmiyorum.

I bought this 6Tb IronWolf Pro NAS drive as backup server for my main servers. I’m using AOMEI backup software (also bought from Amazon) which has an excellent data compression option, so 6Tb is enough. The drive is fast and works perfectly in my spare NAS bay. It is online 24/7 for weekly scheduled incremental backups. This was my preferred choice because it uses CMR technology and is intended for the Enterprise environment. But like some other reviewers I found it very noisy. I could hear the loud hum from the drive two doors down the corridor from my office, and couldn’t tolerate it in the same room. The previous drive in this NAS bay was silent. But I found the answer. There was a tiny gap between the drive and the internal drive housing, and I could wiggle the drive slightly from side to side. So I inserted four tiny, very thin pieces of silicon rubber sheet into each side of the gap – and the noise stopped. I can now be alongside the NAS and remain more or less sane! Great news.

J'ai eu un peu peur au vu des commentaire, ça fait maintenant un peu plus d'un an que je l'utilise alors je vais vous dire ce que j'en pense : J'avoue qu'au premier abord, ce DD fait de temps en temps des petit bruit qui sont assez inquiétants ! Je me suis tout de suite dis que je m'étais fait avoir... mais j'ai quand même décidé, plutôt que de le renvoyer, de le tester durement pour voir s'il tient tout de même ses promesses ! Et bien après avoir rempli d'une traite ses 6to comme un sauvage et malgré les petit bruit inquiétant, celui-ci était très stable en débit, il était même à lui tout seul plus performant que mon vieux raid0 (pour les connaisseurs). Depuis il fait tjrs ses petits cliquetis et autres bizarreries sonores de temps en temps, mais quand j'ai besoin de lui, il fait le taf sans jamais faiblir ! Je tiens à préciser que c'est un disque dur qui met du temps à se mettre en route, donc si vous laissez la mise en veille des disques dur activés, ne vous étonnez pas que son temps d'accès soit long si celui-ci était en veille. Aussi, je conseille de bien l'isoler du reste, car le bruit lié a sa vibration peux être énorme sur des tours standard à tôle fine... personnellement, je ne l'ai pas fixé à la tour, je l'ai posé sur un bout de polystyrène ce qui le rend inaudible. Voilà, c'est un disque qui a des petit défaut, sans doute qu'il n'est pas destiné à être utilisé dans une tour pc, mais plutôt dans un NAS, là où ses petits bruits et vibration ne posent pas trop de soucis... mais passé les petits inconvénients, c'est une véritable machine de guerre... 280mo/s... dingue. Bref perso, je suis satisfait !