Rear Bowtie Emblem Overlay Decal - Fits 2010-2013 Camaro LS, LT, RS, SS

I absolutely love the look of this. I added a few black carbon fiber touches to my green Camaro and it pops. The vinyl is great quality and easy to work with. I didn't get an extra one for the rear like others did. But that's not a big deal. I'm so happy with it. Thanks!

Fit perfectly

Item came as described. The fit was perfect, with installation being all of a literal second. Don’t hesitate to purchase.

The front one was a complete failure but the rear one went on good enough the second time that it's not an eyesore. But I still dont like it, I can still see a very tiny bit of gold where it was too short or I placed it too high. Something happen and now that I see it, its all I see. So I went and got a 5ft by 5ft sheet of 3M vinyl to just redo it. Its 100x easier to slap a piece of vinyl over the whole thing, smooth it out and cut it than it is to use this pre cut stuff. The product isn't bad, just pre cut ain't for me and unless you've worked with vinyl before, I suggest you to steer clear of pre cut. I spent over $20 bucks using pre cut front and back, when I could have just got a $7.99 sheet of 3M vinyl and did front and back and had plenty leftover to do it again 4 or 5 more times.

I have a 2SS/RS Convertible, Red Jewel Tintcoat and all of my accents are black (rally stripes, shark gills, etc). I found this product easy to use if you follow the instructions. I am no decal expert but you need to be patient and work carefully. The product is excellent and there are professionals that can help you apply if you are not skilled. 1. Perform this procedure on a warm day or have a blow drier available to heat the decal before application. 1. Spray the car bowtie and remove backing from decal. Spray the decal backing with water. This will allow you to reposition the decal if not perfectly aligned. 2. Align the center of the bowtie and attach the center only, leaving the two sides dangling. 3. Working from the center, press outward to the left edge, making sure there are no creases and minimizing bubbles. You will always get bubbles and this can be fixed later. 4. Once the left side is done, repeat for the right side. 5. You will see bubbles. Apply your blow drier to heat up the decal surface, then push the bubbles to the edge or break them up as best you can. I recommend you come back in 48 hours to fix the remaining bubbles. 6. Fast forward 48 hours later. Use a pin to prick a hole in the bubbles and force the air out. No worries, you can not see the pin pricks. Voila, you have a very nice look at a reasonable price!

It was easy to put it on and it looks nice the only thing I don't like is the material is made of it seems and feels really cheap for the price

so far so good

I have a Yellow 2010 Camaro with the black stripe package. I thought a black one would set the bow tie off in the back to match the stripes and I was right. It really looks better than the gold did. It was fairly easy to put on. I used a bit of soapy water to help in move a bit and get the air out. Don't use to much as it will move and you do not want the glue to get too wet and run. I had one spot in the corner with something under it but the rest turned out perfect. The shipping was fast and I got it in 3 or 4 days. Nice finishing touch on the rear end.