Poyiccot RJ45 Breakout, RJ45 Screw Terminal Adaptor Connector, 2-Pack 8p8c Female Jack to 8 Pin Screw Terminal Connector for Cat7 Cat6 Cat5 Cat5e Ethernet Extender CCTV Digital DVR Network Adapter

These are great for turning cat 6 into DMX. I buy these often for jobs to turn network line into DMX for LED tape drivers and they have never failed.

I ordered six (total) of these for a wire harness conversion on my 3D printer to CAT6. I initially started with push-down keystones, but the typical wire gauge on my printer (18-20awg) was too large for the keystones and was damaging the terminals. I checked each contact to ensure that there was no issue with shorting, and they seem fine. I also checked the pin orientation, because I've found several different pin orientations for 8P8C screw terminals online: The leftmost pin is Pin 1, and the rest of the pins are sequentially arranged (left to right: 1, 2, 3, 4, 5, 6, 7, 8). This pin orientation is the same on either side; that is, you don't need to mirror the cables if you're using a normal ethernet patch cable. However, if you are using a crossover cable, you WILL need to mirror their orientation. Research patch vs. crossover cable if you aren't sure what this means. If you have a standard, generic, pre-terminated ethernet cable, it is most likely a patch cable. The screw terminal hub on each connector is able to be removed and re-inserted, thus making the terminals modular. Each terminal also has a patch of textured plastic on either side which is great for writing marks with a permanent marker (I use it for a reference mark to determine which terminals match together, as each side of my wire harness uses three identical terminals). Overall: much more expensive than generic RJ45 keystones, but also more rugged, modular, and will accept larger wire gauges than push-down keystones allow for. I'm happy with them.

I was running 2 RS485 serial data lines about 75ft for a power monitor and the easiest way was with an ethernet cable. I could have just chopped the end of the cable off but this left the end on so I can easily plug it in and extend it later if needed.

I couldn’t ask for anything more. Very durable.

I used this for my green house setup: to be able to have an Arduino or in my case an ESP32 in one box with the power, and input signals being sent through on ethernet cord is a godsend for projects. I had a 12v power supply, voltage regulator, esp32 in one box with an ethernet cord connecting my 12v water pump and pneumatic pumps in another box. that way my hoses for my pumps could be routed staight out of the pump box. two small boxes instead of one huge box gave me tons of freedom with my hose routing and made it to were I could have a oled display closer to my house and out of the greenhouse.

So it drives you nuts when you are wanting to see if you have continuity on one of those pins, or a pin shorted, whatever, but your multimeter leads aren't slim enough to contact those fine little pins. Just plug the RJ into this adapter and use your multimeter leads on the break-out screws. Works great! Not enough for you? You can also use this to make a loopback test plug for T1 or ethernet or any other kind of connection. And because it has screw terminals, you can change it around any time. Very handy adapter!

Great

Very good build quality, much higher quality than other adapters I’ve tried

Very easy to work with. Feels solid and robust. Good screw terminal connections allow you to custom wire whatever you need and the kit includes a screwdriver!

Its ok, good but expensive

I am using these units to connect the electronics from the hull into the superstructures to provide Lights, Flood Lamps, Sound Boards etc. Great and very clean way to connect/disconnect electronics when doing maintenance on the models.

It does what it does! It has not changed my life in any way but it's useful!

Permet d'utiliser un câble réseau pour de la domotique rapidement, très pratique bon achat.