ANVISION DC 24V 40mm x 10mm Brushless Cooling Fan, Dual Ball Bearing, 2 Pin

Ordered to replace a fan which had expired after a few years in a video/security recording device. The fan is “always on” and when all other equipment in the room is OFF .... you can hear this guy humming! Obviously it is making noise because it is WORKING and pulling some serious air for its size. Pros: Does it’s job to pull air through the recorder and keep the unit cool. Power for its size. Fair price, not fancy so I wasn’t expecting it to be super “quiet” .... Cons: Too bad it isn’t quieter ... ? Rating: if I could test EVERY fan in this category, I might only give this one 4 stars IF there was something that I knew could perform BETTER with less noise. However, there’s only SO MUCH a small fan can DO ... I would buy it agin ... YES

It spun smoothly with no odd vibrations and was not too loud. Also seemed to have an actual ball bearing inside which was nice. Was used as an exhaust fan which pulls air through a restrictive grill and it moves a decent amount of air. I will update this review if the fan dies or starts making weird sounds.

Purchased this fan to replace the extruder cooling fan on a Creality Ender 3 Pro 3D Printer that completely died. I selected this fan because it has ball bearings, not sleeve bearings and because it comes equipped with JST-XH type 2.54mm 2 Pin female connector. To make the connection with the original wires back to the control board, I purchased a JST-XH type 2.54mm 2 Pin male connector (Amazon #B07YKHV46N) and 3/32" red & black 3:1 heat-shrink tubing (Amazon #B08KLSGKTG). A little soldering and heat gun action gave me the matching male connector in place. Reassembled everything without trouble. Fan works great though it does make a tiny high-pitched whine that the original Creality fan did not have so I subtracted 1 star. Still, since this fan is always on when the printer is on, I am hoping this fan lasts a long time with the improved bearings. Regardless, if this fan does not last longer, at least it will be easy to replace now that I have equipped the printer with the JST-XH type connector!

Needed a small mountable cooling fan for a project and stumbled across these in my search. Bought one and liked it some much a bought a few more to have in my supply drawer for other projects. They're quiet and push a good amount of air for their size. Motor bearings seem to be good as I've used a few of these with no issues so far. They just work and work well. Good part, highly recommend.

Fan is working well, but it is pretty loud. Wish it was lower noise.

Fixed my diffuser ! Very easy to install

Fan is nice and strong and very quiet. Works great. When I first installed this fan, the polarity of the old fan and plug was opposite of this new fan and it did not work. I contacted the seller and they said they test every fan before it ships, so they knew it was working at the time of shipment, and suggested I verify the polarity, and sure enough that was the issue. I swapped the wires and the Fan worked great.

This has been running non-stop for 3 years without being cleaned to keep air circulating in a vivarium. well worth it.

This one works quietly and moves a fair amount of air for the speed/noise level. Very nice.

Weak airflow, only 0.024A (0.58W) instead of 0.06A

+++++av 5

Planladığım bir uygulama vardı, tam uygun çıktı. Minicik fandan umulmayacak randıman. Sessizce...

Good