Frankford Arsenal Powder Trickler with Large Powder Capacity and Convenient Height for Reloading, Blue

This is one kick butt powder trickler. It's solid as a rock, meaning well made and heavy. It has a good height that works well with most powder scales and is easy to use. I'm using it for my rifle reloads and this trickler will drop whatever powder you are using and do it very precisely. I use mostly stick powders for my rifle loads and it will drop as little as one stick at a time. Frankford Arsenal did a great job on this trickler and at a very good price. I'm not sure how I managed without one.

If you are considering a trickler, this is the best one, in terms of function and "tool grade" quality, in my opinion. And the best value for the money. It is heavy steel and very stable. The machining is clean and it is nice to have covers for the receptacle and tube.

This trickier is excellent. It functions as you would expect, is easy to controll and gives accurate powder drops. The construction is solid and easy to maintain.

Nice trickler . Weighted bottom no tipping

Works well and top rubber cap and little open end rubber cap fit very snug. I leave gunpowder it when I store it in my ammo can w/ a dry desiccant pad. Very stable and heavy weight.

Sturdy, accurate, and pretty consistent to trickle. Frankford typically produces high quality reloading items, and this is one of those quality items.

With over 1200 positive reviews on here I felt sure I would find answers to my specific questions, but to my disappointment, I did not. So... Yes, this is an amazingly accurate dispenser. How accurate? My high quality digital powder scale reads to one place to the right of the decimal (tenths). I have not seen many scales less than several hundred dollars with a higher resolution. That said, this trickler would be accurate enough to read to hundredths no doubt. As I load only pistol calibers, I used this item extensively with Winchester W244 ball powder and Hodgdon CFE pistol, HP-38 and Titegroup. All these powders differ slightly, some fine and powdery like Titegroup and some chunkier like HP-38. It worked great with all of them. I was a little miffed to see the product came with no instructions whatsoever; but then, it is fairly self-explanatory. Fill with powder above the metering rod (the horizontal bar you turn to dispense powder), then spin the rod until powder begins to trickle out of the end. It does take a bit of spinning to fill the worm thread that carries the powder down the rod There are what I consider a "coarse" and a "fine" knob on the rod end opposite the dispensing end. The larger diameter knurled knob is coarse while the rubber covered smaller diameter knob would be the fine. Using what I will call "blips" applied to turn the knob will yield approximately the following, differing slightly from powder to powder: - Two blips of the coarse knob (about one full revolution of the rod) will dispense one tenth of a grain, while four blips of the fine knob (also one revolution of the rod) will yield the same amount. I use a dipper to get close to my charge target in the scale pan, then trickle to the target charge. Dead accurate. Now, I don't always charge pistol ammo manually, but I just got a $600 Garmin chronograph (love it) and decided to do a broad spectrum high precision test load lot of 9mm, .38 Special and .44 Magnum loads to see just how consistent I can get velocities. This endeavor, while painful, would have been excruciating difficult without this trickler. Only one negative: Once you're done loading and want to clean up or change powders, quite a bit of powder remains in the lower half of the trickler reservoir no matter how much you shake and tap. The only remedy I've found is to remove the metering rod and wash the reservoir out followed by a thorough dry. I even tried swabbing it out with alcohol to lower surface tension and allow the powder to be dumped out, but no cigar. I'll live with it. I use Lee reloading products almost exclusively and have for 34 years, but this trickler joins my Frankford Arsenal dry tumbler and priming tool, and all are of the highest machine quality and flawless function. Can't go wrong and the price is more than fair.

Excellent powder sprinkler. Has a good weight and stays put when sprinkling powder with one hand. Good height to allow discharge spout to reach powder measuring bowl.

Very heavy and well made. Does exactly what you need and doesn’t bounce around while you’re trying to do it because it’s nice and heavy. Especially for my big ass shrek hands, it’s easy to use and precision is easily achieved.

article conforme et pratique a l utilisation , stable

Articolo come da descrizione, ben fatto, molto stabile e pratico, funziona bene

Heavy, solid piece of kit, Very accurate, used to dispense black powder to avoid static hazard in the electronic dispenser

Paket war sehr schnell hier. Das Produkt von hervorragender Qualität. Gerne wieder!