iGreely USB to DC 5V to 12V Voltage Step Up Converter Cable - 3ft/1m, DC Jack 5.5 x 2.5mm or 5.5 x 2.1mm, USB Charger

working perfectly as a replacement for the ac adapter to my Tapo smart LED lightstrip. the DC jack fits perfectly! Highly recommended. reliable - wroking for more than 2 months straight

I work with network equipment and often have to use small Netgear switches or media converters in racks or whilst moving about. There are often no mains sockets available. This lets me power the switch or media converter from my laptop, or even a convenient USB port on the equipment itself, like on most Cisco gear. You do need to check it won't pull too much current, but it's fine for most reasonable use cases. Robust enough as well. Maybe my only complaint is the electronics are all in the plug, which is quite deep. This sometimes means you can plug it or leave it plugged in with limited space. If it was in a blob on the middle of the cable, you could do this. I tried another type of this cable before and it was not nearly as robust or stable.

This device works well so far. I've only briefly tested it with four 12v fans with a current draw of 0.08A each. They're pulling a total of 0.37A consistently when powered using this cable and a OnePlus fast charger which can provide up to 5A. Will report back when I've tested it using different power supplies. Listing says it needs a minimum of 2A to even work so I'll see if that's true. It does get noticeably warm in my use case but so far doesn't seem to be overheating when given sufficient power, some heat dissipation is normal given the job its doing. Connector seems stable, cable seems fit for purpose. I don't think this circuit is a difficult one to manufacture but to get a reliable one that doesn't overheat, ya do have to spend a few more quid. Avoid getting those 10 x boost converter module packs as they tend to overheat massively and can output very little current. Would recommend this cable so far!

Great product, that allows you to connect 12 volt item to a USB port. We used this to power a wireless router with a power bank.

I had really high hopes for this product. At first it seemed it would work well for powering my ATEM Mini, the Mini booted up, all the buttons lit up etc. However, after a couple of minutes the signal dropped and the Mini started making a warning sound, so I quickly unplugged the device. I assume there was a problem with the amount of power getting to the Mini so decided to return the cable. I have nothing else to try the cable with so cannot say if the cable was faulty or just not compatible with the ATEM Mini.

worked well - now run an outside controller off a USB (PD) battery instead of Mains adapter - much better.

Excellent idea, but did not supply the power to be able to use on the Brother P-Touch 1005. Bit of a failure.

Very hand adapter to fit my Masterbuilt gravity 800, allows me to supply it with a power bank.

These cords work great for the monitor for my Bach up camera. The supplier provided the link to order them easily. If you need this cable, I would recommend purchasing these cables.

ممتاز لتشغيل الراوتر والرسيفر وغيره

حلو جدا وشغال مع الباور بانك وبيشغل الراوتر

Prodotto di buona fattura, usato per accendere una striscia led di 50 centimetri dietro il televisore utilizzando la porta USB dello stesso, Funziona egregiamente oramai da qualche mese. Ho dato quattro stelle perché le specifiche tecniche sono carenti, ovvero non è scritto quanti milliampere supporta come carico, specifica tecnica molto importante.

It is working, I don't know for how long but looks not so bad