Waldom W-HT-2038 Tool Extractor, 0.093" Contacts, 14-30 AWG for 0.062" Diameter Pins, Brass Color

This tool works great for removing the 0.062 in. male and female Molex pins. Much easier than trying to remove the pins with a screwdriver. Very well built tool. Just place over each pin, apply a little bit of pressure to center the tool in the Molex connector hole, then apply a little more pressure and the spring loaded end of the tool pops the Molex pin and wire out from the opposite end of the connector.

This is awesome. It really works. The black tip is spring loaded. You press it over the molex pin to remove and push till you feel the inside touch the tip of the pin. Then just keep pushing and the pin is extracted. Couldn't be easier.

Not delivered in Waldom original packaging. Arrived defective. Spring loaded barrel will not move.

Pushes pins like it ain't no thang. This is the tool you want if you do a lot of molex pins and need a tool that will not fail. Recommended for professionals. Plus, it looks super sweet with its yellow anodizing. Added bonus if you are a Green Bay Packers fan (such as myself) and if you own the smaller one of these. Its green :)

This tool was used once at work because the pin needed an extractor tool with this particular diameter to extract it out and solder the wire back into place. Will use it again when the time comes. No complaints.

Based on the great reviews, I feel I must be using this wrong. But- it ain't rocket science. I push this onto a pin and expect it to snap out - is that wrong? I typically use the black plastic "plunger" type with no issue, except it's a little hard to manage in tight spaces. I thought this would be better since I don't need one hand to press a plunger. But all I manage to do is make it even harder to get out. It seems to be jamming the wings into the plastic before they are fully compressed. Very thankful I was able to pull them out with needle nose pliers, luckily without breaking wires. This happened with 2 pins I tried it on, then I went back to using the old trusty plunger type without fail. Guess I just don't get it. Will be returning but hate to rate it poorly when maybe it's just me? IDK

EDIT- Does not pop .093 female pins easily. Pops the male pins no problem. I had to bang the tool on a surface while connected to the connector to get it to pop a female pin. So yes, it works, but it takes a lot of effort

Works on Male and Female pins, I found it slightly easier to use on the Male pins. Spring loaded for easy extraction. A Must-Have for anyone making or modifying Molex Harnesses.